Bulkhead Fuel Pump Harnesses and Connectors

$80.70

NOTE: These wiring harness connectors were used in Radium Engineering products in the past. For a complete bulkhead mating connection, select one internal and one external harness from the lists above.

INTERNAL AND EXTERNAL BULKHEADS
External harness wires use 24" long 10AWG TXL insulated wires. Internal harness use twin 16 AWG ETFE insulated wires.
4-Pin metal shell bulkheads and flying lead connectors are available and can be referenced by the part numbers shown in the photo below.

Radium no longer carries the mating flying-lead or connector kit for these 7-pin bulkheads.

EXTERNAL ELECTRICAL BULKHEAD CONNECTORS
These bulkheads can be used for rebuilding a damaged connector or for DIY installation.

Metal shell 4-way connector shown above.

PANEL REQUIREMENTS
All panels must be 0.06-0.18 inches thick. See the drawing below for cutouts for each bulkhead connector. A gasket is included on the large connector and the small connector includes an O-ring for sealing against panel surface.

PINOUTS
If wiring a connector to a Radium Engineering internal harness, the pinouts are below.